| 【Perfomance and characteristics】 | 【性能与特点】 |
| • The system is configured with 3 action modes. | • 系统配置有3 种操作模式。 |
| a.Lubricating: when turning on, execute lubricating timing. | a.润滑：开机时执行润滑定时。 |
| b.Intermittent: execute intermittent timing after lubricating is completed(Time unit convertible). | b.间歇：润滑完成后执行间歇计时（时间单位可转换）。 |
| c.Memory: in case of power on after power off, resume incomplete intermittent time. | c.记忆：断电后重新上电时，恢复不完整的间歇时间。 |
| • Lubricating time and intermittent time can be adjusted. (Built-in locking function, and lubricating and intermittent time after setting is locked). | • 润滑时间和间歇时间均可调节。 （内置锁定功能，设定后润滑及间歇时间被锁定）。 |
| • Provided with liquid level switch and pressure switch (optional). When oil volume or pressure is insufficient, the beeper makes sound, send alarm and offers abnormal signal output. | • 配备液位开关和压力开关（可选）。当油量或压力不足时，蜂鸣器发出声音，发出警报并输出异常信号。 |
| a.When pressure is insufficient, Erp is displayed. | a.压力不足时，显示Erp。 |
| b.When liquid level is insufficient, Ero is displayed. | b.液位不足时，显示Ero。 |
| • The system time can be configured, LUB lubricating time: 1-999 (seconds) INT intermittent time: 1-999 (minutes) (Tailored if specially required) | • 系统时间可配置，LUB润滑时间：1-999（秒） INT间歇时间：1-999（分钟）（如有特殊要求可定制） |
| • The panel indicator displays lubricating and intermittent status, | • 面板指示灯显示润滑和间歇状态， |
| • The system uses RST key to force lubricating or eliminate abnormal reporting signal. | • 系统使用RST键强制润滑或消除异常报告信号。 |
| • Single maximum lubricating time ≤ 2 min, and intermittent time is at least 5 times of the lubricating time. | • 单次最大润滑时间≤2分钟，间歇时间至少为润滑时间的5倍。 |
| • The motor is provided with self-protection function to avoid high motor temperature and overload. | • 电机具有自我保护功能，避免电机高温和过载。 |
| • No decompression device is provided with resistance-type system, used with proportional joint distributor. | • 电阻式系统不带减压装置，与比例接头分配器配合使用。 |
| • Overflow is provided to protect oil injector and pipeline from being damaged byhigh pressure. | • 设有溢流装置，保护注油器和管道免受高压损坏。 |
@ 2024 Sino Solutions, All Rights Reserved.
