BTA-C1 PLC Control Thin Oil Lubricating Pump 控制稀油润滑泵

SKU: BTA-C1

Product Description
  • Pressure Switch 2L/3L/4L
  • Single Phase 220V 200cc/min Connected to ф 6pipe
  • Liquid level switch and pressure switch (optional) are provided. When oil volume or pressure is insufficient,abnormal signal is output.
  • The panel indicator light indicates power and lubrication status if the oil injection mold. •The system is provided with FEED key, and compulsory lubrication is applied.
  • Time setting: single maximum lubrication duration ≤2min,and the intermittent time is at least 5 times of the lubricating time.
  • The motor is provided with self-protection to prevent high temperature and overload of motor.
  • No decompression device is provided with resistance-type system,used with proportional joint distributor.
  • Overflow valve is provided to prevent damage by oil injector and pipeline.Internal fuse is provided to prevent IC board and motor damaged by short circuit.

 

  • 压力开关 2L/3L/4L
  • 单相 220V 200cc/min 连接 ф 6 管
  • 设有液位开关及压力开关（选配），当油量或压力不足时，输出异常信号。
  • 注油模具，面板指示灯指示电源及润滑状态。
  • 系统设有FEED键，采用强制润滑。
  • 时间设定：单次最大润滑时长≤2min，间歇时间至少为润滑时间的5倍。
  • 电机设有自我保护，防止电机高温、过载。
  • 电阻式系统无减压装置，与比例接头分配器配合使用。
  • 设有溢流阀，防止注油器及管路损坏。内部设有保险丝，防止短路损坏IC板及电机。

Whatsapp
Facebook Instagram Map-marker-alt
BAOTN BANNER INFORMATION-01
RESTAT INFORMATION BANNER-01 (1)
SINO BANNER INFORMATION-01

@ 2024 Sino Solutions, All Rights Reserved.

Let's Chat