BTA-A2 Thin Oil Lubricating Pump with Digital Display 数显稀油润滑泵

– Pressure Switch 2L/3L/4L Single Phase

– 220V 200cc/min Connected to ф 6pipe

The system is configured with 3 action modes.

a) Lubricating: when turning on, execute lubricating timing.

b) Intermittent execute intermittent timing after lubricating is completed (Time unit convertible).

c) Memory: in case of power on after power on, resume incomplete intermittent time.

• Lubricating time and intermittent time can be adjusted (Built-in-locking function,lubricating and intermittent time after setting is locked).
• Provided with liquid level switch and pressure switch (optional). When oil volume or pressure is insufficient ,the beeper makes sound,send alarm and offers abnormal signal output.
  • a) When pressure is insufficient, Erp is displayed.
  • b) When liquid level is insufficient, Ero is displayed.
•  The system time can be configured,”LUB” lubricating time: 1-999 (seconds) ”INT” intermittent time: 1-999(minutes) (Tailored if specially required).
• The panel indicator displays lubricating and intermittent status.
• The system uses RST key to force lubricating or eliminate abnormal reporting signal.
• Single maximum lubricating time ≤2min,and intermittent time is at least 5 times of the lubricating time.
• The motor is provided with self-protection function to avoid high motor temperature and overload.
• Decompression device is provided with volumetric system,used with BFA/BFB/BFC/BFD/BFE/BFG distributor.
• Overflow is provide to protect oil injector and pipeline from being damaged by high pressure.

【性能与特点】 系统可设定三种动作模式。

– 压力开关 2L/3L/4L

– 单相 220V 200cc/min 连接 ф 6管

a) 润滑: 开机时先执行润滑时间计时。

b) 间歇: 润滑完成后执行间歇时间计时 (时间单位可转换)。

c) 记忆: 断电后再次送电可继续执行之前未完成的间歇时间。

•润滑时间和间歇时问均可调整。(内设有锁键功能，可锁定设置后的润滑和间歇时间)

•设有液位开关，压力开关(可选配)。当油量或压力不足时蜂鸣器会发出报警，并将异常信号输出。

a) 压力不足显示Erp。

b) 液位不足显示Ero。

•系统时间可设定，”LUB”润滑时间: 1-999(秒) “INT”间歇时间: 1-999(分) (特殊要求可定制)

•面板指示灯可显示出注油机的润滑和问歇状态。

•系统可使用”RST”键，强制润滑或消除异常报警信号。

•单次最长润滑时间 ≤2min,问歇时间通常为润滑时间的5倍以上。

•电机设有自我保护功能，防止电机温度过高及过载。

•在容积式系统中无脱压装置，需配合BFA/BFB/BFC/BFD/BFE/BFG分配器使用。

•设有溢流阀，可保护注油机及管路由于压力过高而损坏。